A.S.T.S(Anti Skipping Tone-arm System)
A.S.T.S(Anti Skipping Tone-arm System) has been developed with years of experience and a number of trials, searching for the innovative tone-arm for professional DJ's.This system breaks all of the historic common sense, achieving its non skipping performance in hard scratching. A.S.T.S consists of two inventions, short/straight arm and TH (Tracing Hold) balance system.
●TH balance system gives horizontal movement in addition to vertical. This movement gives much more stable balance (vertical direction) to the needle. The combination of short / straight arm and TH balance system gives the best stability to the needle, which enables anti-skipping in hard scratching.
●The brass arm with aluminum cover is used for A.S.T.S . This combination results in the best pick up sensitivity as well as the best resistance to howling. This new tone-arm allowed A.S.T.S to increase the resistance against the howling by over 50% compared to the normal aluminum arm.
REMOTE CONTROL
It is possible to control two turntables remotely.
○1 Prepare for 3.5mm monaural phone plug cable Turn on Sync ON/OFF SW.
○2 Connect REMOTE OUT JACK at the rear panel with another PDX-8000 REMOTE IN JACK at the rear panel by using the cable.
○3 The player connected at the REMOTE OUT JACK is MASTER of the PDX-8000. The player connected at the REMOTE IN JACK is the Slave of the PDX-8000.
○4 Pushing START/ STOP SWITCH of the master PDX-8000 will make the connection between master PDX-8000 and slave PDX-8000. Then slave PDX-8000 acts the same as master PDX-8000 without touching slave PDX-8000. Connecting the REMOTE IN JACK of third PDX-8000 with REMOTE OUT JACK of slave PDX-8000, third PDX-8000 will also act the same as master PDX-8000 It is possible to connect a fourth PDX-8000, to be controlled the same as master PDX-8000 by REMOTE CONTROL.