Philips CDR 560 Power supply, Inserting batteries in the remote control, Set-uprecommendations

Models: CDR 538 CDR 560

1 55
Download 55 pages 7.74 Kb
Page 12
Image 12
Power supply

English

INSTALLATION

Power supply

 

Inserting batteries in the remote control

1Plug the power cord supplied into the MAINS connector on the CD recorder, then into a wall socket.

2Press ON/OFF to turn the CD recorder on.

Note:

-The CD recorder will automatically adjust to the local mains voltage.

-When the CD recorder is in the “OFF” position, it is still consuming some power. If you wish to disconnect your CD recorder completely from the mains, withdraw the plug from the AC Outlet.

Set-up recommendations

-Place the CD recorder on a solid, vibration free surface.

-Do not place the CD recorder near a source of heat or in direct sunlight.

-Do not use the CD recorder under extremely damp conditions.

-If the CD recorder is placed in a cabinet, make sure that a one-inch space remains free on all sides of the recorder for proper ventilation.

CDR 560

Note: For CDR538 see Remote Control FW538.

1Open the battery compartment cover.

2Insert 2 batteries (AAA, R03 or UM-4; as supplied) as shown.

3Replace the cover.

Note: We recommend using 2 batteries of the same type and condition.

Batteries contain chemical substances; dispose of them properly.

10

Page 12
Image 12
Philips CDR 560 Power supply, Inserting batteries in the remote control, Set-uprecommendations, Installation, English