GENERAL INFORMATION
CAUTION
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
The set complies with the
CDN Canada
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications.
Cet appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables dans la règlement sur le brouillage radioélectriques édicté par le ministère des communications du Canada.
CAUTION
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERTED.
ATTENTION
POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPON- DANTE DE LA PRISE ET POUSSER JUSQU AU FOND.
LASER
Type | Semiconductor laser GaAlAs |
Wave lenght | |
Output Power | 2,5 mW (Read) |
| 35 mW (Write) |
Beam divergence | 60 degree |
This warning label is located on the rearside and inside this laser product.
CAUTION: INVISIBLE LASER RADIATION
WHEN OPEN. DO NOT STARE INTO BEAM DANGER: INVISIBLE LASER RADIATION WHEN OPEN.
AVOID DIRECT EXPOSURE TO BEAM.
VARO! AVATTAESSA JA SUOJALUKITUS OHITEJTAESSA OLET ALTTIINANAKYMATTOMAALLE LASERSATEILYLLE.ALA KATSO SATEESEEN.
OSYNLIG LASERSTRÅLNING NÄR DENNA DEL ÄR ÖPPNAD VARNING!OCH SPARREN AR URKOPPLAD. BETRAKTA EJ STRALEN
or
DANGER - Invisible laser radiation when open.
AVOID DIRECT EXPOSURE TO BEAM
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC (U.S.A.) RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS : (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
NOTE
This equipment has been tested and found to comply with | If this equipment does cause harmful interference to radio |
the limits for a Class B digital device, pursuant to part 15 | or television reception, which can be determined by |
of the FCC Rules. These limits are designed to provide | turning this equipment off and on, the user is encouraged |
reasonable protection against harmful interference in a | to try to correct the interference by one or more of the |
residential installation. This equipment generates, uses and | following measures : |
can be used in accordance with the instructions, may | - reorient or relocate the receiving antenna. |
cause harmful interference to radio communications. | - increase the separation between the equipment and |
However, there is no guarantee that interference will not | receiver. |
occur in a particular installation. | - connect the equipment into an outlet on a circuit |
| different from that to which the receiver is connected. |
| - consult the dealer or an experienced radio/TV technician |
| for help. |
IMPORTANT
THIS PRODUCT WAS FCC VERIFIED UNDER TEST CONDITIONS THAT INCLUDED USE OF SHIELDED CABLES AND CONNECTORS BEWTEEN SYSTEM COMPONENTS. IT IS IMPORTANT THAT YOU USE SHIELDED CABLES TO REDUCE THE POSSIBILITY OF CAUSING INTERFERENCE TO RADIOS, TELEVISION SETS AND OTHER ELECTRONIC DEVICES.
IF YOU HAVE ANY PROBLEMS CONTACT YOUR DEALER.
ANY CHANGE OR MODIFICATIONS TO THE EQUIPMENT BY THE USER NOT EXPRESSLY APPROVED BY THE GRANTEE OR MANUFACTURER COULD VOID THE USER’S AUTHORITY TO OPERATE SUCH EQUIPMENT.
