6. OPERATIONS

Basic Operations

Note: Be sure to read this chapter referring to the front diagrams of

chapter “3. CONTROLS” on page 5 (unfold).

CAUTION

Be sure to lower the volume before switching off the unit power or the ignition key. The unit remembers its last volume setting. If you switch the power off with the volume up, when you switch the power back on, the sudden loud volume may hurt your hearing and dam- age the unit.

The clock is displayed when the ignition key is turned to the ACC (accessory) or IGN (igni- tion-on) position even when the unit power is off. In some cars, the clock may momen- tarily disappear when the ignition key is turned to the START position. The clock will reappear after the engine has started and the ignition key is released to the IGN (ignition- on) position.

Radio mode CD mode Tape mode CD changer mode MD changer mode TV mode Radio mode...

External equipment not connected with CeNET is not displayed.

Adjusting the volume

Press Up button & or Down button * increases or decreases the volume.

The volume level is from 0 (minimum) to 33 (maxi- mum).

Switching the display

Press DISP button 3 to select the desired dis- play.

Each time you press DISP button 3, the display switches in the following order:

Main display

Turning on/off the power

Notes:

Be careful about using this unit for a long time with- out running the engine. If you drain the car’s bat- tery too far, you may not be able to start the en- gine and this can reduce the service life of the battery.

System check

This unit checks what external equipment is con- nected to the CeNET. The first time the ACC/Igni- tion is turned on (initialization), “SYSTEM” and

Push PWR” alternately blink in the display. Press POWER button 7to start the system check. When complete, press POWER button 7 again to acti- vate the unit then the unit appears CHECKING COMPLETE.

1.Press POWER button 7.

2.The illumination and display on the unit light up. The unit automatically remembers its last operation mode and will automatically switch to display that mode.

3.Press and hold POWER button 7 for 1 sec- ond or longer to turn off the power for the unit.

Selecting a mode

1.Press FUNC button 7 to change the mode of operation.

2.Each time you press FUNC button 7, the mode of operation changes in the following order:

Sub (title) display

Clock display

Main display...

ADX5655z 9

280-7452-00

Page 10
Image 10
Clarion ADX5655z, PE-2322B owner manual Basic Operations