English | Inserting the Battery | |
1 Slide remote control unit’s rear cover in the | ||
| ||
| direction shown. | |
| 2 Insert battery (CR2025) into insertion guides | |
| with printed side (+) up. | |
| 3 Press battery into compartment as shown. | |
| 4 Replace and slide cover until it clicks into | |
| place. |
Insertion guide
CR20 
2 
5
Notes:
Misuse may result in battery rupture and fluid leakage, resulting in personal injury or damage. Always follow these safety precautions:
•Use only the designated battery.
•When replacing the battery, insert with +/– polarities correctly oriented.
•Do not subject battery to heat, or dispose in fire or water. Do not attempt to disassemble the battery.
•Dispose of used batteries properly.
6. OPERATIONS
Note:
•Refer to the diagrams in “3. CONTROLS” (page 5) when reading this chapter.
Basic Operations
CAUTION
Be sure to lower the volume before switching off the unit power or car’s ignition key. The unit remembers its last volume setting.
Turning power on/off
1.Press the [SRC] button to turn on power.
2.Press and hold the [SRC] button (1 sec.) to turn off power.
Selecting modes
1.Press the [SRC] button to change operation mode.
2.Each time the [SRC] button is pressed, the operation mode changes as follows: Radio ➜ CD/MP3/WMA ➜ AUX ➜ Radio...
Adjusting the volume
1.Turn the [ROTARY] knob clockwise to increase volume; turn counterclockwise to decrease volume.
∗Volume range is 0 (minimum) to 33 (maximum).
Switching the display
Press the [DISP] button to select desired display.
8 CZ109
