DPX1001.2 Power System Amplifier
Problem
Audio lacks punch.
Solution
Speakers wired incorrectly, which causes cancellation of bass frequencies. Check polarity of wires from amplifier to each speaker as defined by the system design.
Problem
Amplifier fuse keeps blowing.
Solution
Incorrect wiring or short circuit. Review Installation and check all wiring connections.
Problem
Whining or ticking noise in the audio with engine on.
Solution
Amplifier is picking up alternator noise or radiated noise. Turn down input gain; move audio cables away from power wires. Check power and ground connections on amplifier; install an
PRODUCT SPECS
Frequency Response | 20Hz ~ 20kHz |
Signal Noise Ratio | >95db |
THD | .2% all channels driven |
Input Sensitivity Low Level | 250mV ~ 2.5 V |
Input Sensitivity Speaker Level | 500mV - 5V |
Max. Power Output | 500 watts x 2 @1 ohm |
Cont. Power Output | 150 watts x 2 into 4 ohms @ <1% THD |
300 watts x 2 into 2 ohms @ <1% THD | |
Bridged Power | 1000 watts x 1 into 2 ohms @ <1% THD |
Dimensions | 2 1/8” H x 8 1/4” W x 14” L |
Current Consumption at output @ max | 86A @ 1000 Watts |
power |
|
14