OPERATIONS

Adjust Mode

Anti-theft indicator

The red Anti-theft indicator is a function for detering theft. When the DCP is removed from the unit, this indicator blinks.

• The factory default setting is “OFF”.

1.Press the [ADJ] button to switch to the adjust mode.

2.Move the [ ] / [ ] lever to select “LED”.

3.Turn the [ROTARY] knob to select “ON” or “OFF”.

4.Press the [ADJ] button to return to the previous mode.

Setting the low pass filter

•This function can only be adjusted when the subwoofer output is set to “ON” and the speaker system is set to “5.1ch”. For details on how to set the subwoofer, refer to the subsection “Turning on/off speakers” (P. 39) in the section

“Changing Initial Settings such as Menu Language, etc.”.

•This function cannot be adjusted when as follows: “Pro Logic” is set to “ON”, the speaker system is set to “5.1ch”, DVD/DTS-CD is being played.

•The factory default setting is “THROUGH”. If the speaker system is set to “5.1ch”, the factory default setting is “50Hz”.

1.Press the [ADJ] button to switch to the adjust mode.

2.Move the [ ] / [ ] lever to select “SW LPF”.

3.Turn the [ROTARY] knob to select the setting. Each time you turn the [ROTARY] knob, the setting changes in the following order:

THROUGH ➜ 50Hz ➜ 80Hz ➜ 120Hz

4.Press the [ADJ] button to return to the previous mode.

Setting the amplifier bypass circuit

• The factory default setting is “OFF”.

1.Press the [ADJ] button to switch to the adjust mode.

2.Move the [ ] / [ ] lever to select “AMP CNCL”.

zOFF:

Uses with inside AMP.

4.Press the [ADJ] button to return to the previous mode.

Selecting AUX/TEL

You can listen to sounds and music from external devices or your telephone calls from the speakers when connected to this unit. When TEL INT or External device is connected to this unit, you can select TEL mode or AUX mode.

• The factory default setting is “AUX”.

1.Press the [ADJ] button to switch to the adjust mode.

2.Move the [ ] / [ ] lever to select “AUX/TEL”.

3.Turn the [ROTARY] knob to select “AUX” or “TEL”.

zAUX:

AUX/TEL input cable is for external Audio input.

zTEL:

AUX/TEL input cable is for cellular phone audio input.

4.Press the [ADJ] button to return to the previous mode.

Adjusting the auxiliary input sensitivity

Adjust the auxiliary sensitivity when the audio from an external device is difficult to hear even after adjusting the volume.

• The factory default setting is “MID”.

1.Press the [ADJ] button to switch to the adjust mode.

2.Move the [ ] / [ ] lever to select “AUX SENS”.

3.Turn the [ROTARY] knob to select from “LOW”, “MID” or “HIGH”.

4.Press the [ADJ] button to return to the previous mode.

English

3.Turn the [ROTARY] knob to select “ON” or “OFF”.

zON:

Uses with connected AMP.

VXZ768R 45