Clarion Sales Corporation, 661 West Redondo Beach Blvd.
Gardena, CA
Ontario L6H 5R1, Canada Phone: (905)
Owner’s Manual
AUTOMOTIVE INFRARED
STEREO HEADPHONE SYSTEM
Model: WH100
INTRODUCTION:
Congratulations on your purchase of a sophisticated, high- tech Clarion Automotive Infrared Stereo Headphone System.
This system frees you from the tangle of Headphone wires and lets you enjoy music or TV without the tangle of cables around you. To ensure the best performance of your system, please read this manual carefully.
EXPLANATION OF CONTROLS: (Fig. 1)
Infrared Transmitter:
1.Infrared Emitting Leds - Transmit signal to headphones
Headphone Receivers:
2.Infrared Sensors - Receive signal from the transmitter
3.Battery Cover
4.Volume Control
5.Power Switch
6.Power Indicator Led
7.Auto ON/OFF Micro Switch
BATTERY INSTALLATION: (Fig. 2)
1.Place two (2) alkaline AAA batteries into the battery com- partment of the Headphones, making sure that the battery polarity is correct.
SPECIAL FEATURES:
nAutomatic Level Control prevents input signal over loading.
nUses high frequency infrared light to assure a clean sig- nal for clear reception.
nAdjustable Headphone band.
Fig. 1
Auto ON/OFF Switch is activated when headphones are placed on head.
OPERATION:
Please read carefully to prevent damage to the Headphones or your ears.
1. | Be sure batteries are properly installed in the |
|
| Headphones. |
|
2. | Turn the Headphone volume nearly off before turning on | Fig. 2 |
| the power. Turn on the Headphone power then adjust the |
|
| Headphone volume louder to a comfortable level. (You |
|
| can adjust the audio source volume louder if needed). |
|
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resi- dential installation. This equipment generates, uses and can radiate radio fre- quency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televi- sion reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct interference by one or more of the following measures:
nReorient or relocate the receiving antenna.
nIncrease the separation between the equipment and receiver.
nConnect the equipment into an outlet on a circuit different from that to which the receiver is needed.
nConsult the dealer or an experienced radio/TV technician for help.
