6.MAINTENANCE & TROUBLESHOOTING
6.5Error Messages
In addition to alarm messages your equipment displays error messages to alert you of potential equipment trouble
.
Error messages
Error message | Meaning |
| Remedy | ||
| Communication between the control | Check | the | interconnection | |
| unit and the processor unit is | ||||
COMMUNICATION ERROR | cable | between control unit | |||
interrupted for more than two | |||||
| and processor unit. | ||||
| seconds. | ||||
|
|
|
| ||
INSTANT POWER FAIL IS | Power supply was interrupted for | Press any key on the control | |||
OCCURRED | more than two seconds. | unit. |
|
| |
| The rudder angle sent from the | Check | the rudder reference | ||
RUDDER ANGLE ERROR | unit, rudder | angle and its | |||
rudder reference unit exceeded 55°. | |||||
| connection cable. | ||||
|
| ||||
| The rudder did not move more than | Check the hydraulic system. | |||
RUDDER DRIVE ERROR | 3° over 10 seconds after rudder | After the solving problem, do | |||
| command. | the rudder test. | |||
DRIVE UNIT ERROR. PLEASE | Slight current is occurred while no |
|
|
| |
TURN OFF AND CHECK DRIVE | Check the drive circuit. | ||||
operation. | |||||
CIRCUIT. |
|
|
| ||
|
|
|
| ||
DRIVE UNIT IS OVERLOADED. | Overcurrent was detected. Current |
|
|
| |
PLEASE TURN OFF AND | of more than 50 A was detected on | Check the drive circuit and | |||
CHECK DRIVE CIRCUIT. | the drive circuit without rudder | bypass circuit. | |||
| command. |
|
|
| |
DRIVE UNIT IS OVERHEATED. | 80°C temperature in drive unit was | Check the drive unit system. | |||
| detected. |
|
|
| |
BYPASS/CLUTCH IS | Current of more than 5 A was |
|
|
| |
OVERLOADED. | detected on the bypass/clutch | Check | the | bypass/clutch | |
| circuit. | ||||
| circuit. |
|
| ||
DISCONNECT B/C | No current on the bypass/clutch |
|
| ||
|
|
| |||
circuit. |
|
|
| ||
|
|
|
| ||
FU REMOTE CONTROLLER | Command from the FU remote | Check the remote controller | |||
ERROR | controller exceeded 55°. | connection. |
| ||
MISSING HEADING DATA | The heading data from the heading | Check | the | heading sensor | |
sensor is missing for 600 ms. | and interconnection cable.. | ||||
| |||||
HEADING DATA ERROR | Heading data with error flag was | Check the heading sensor. | |||
detected three times continuously. | |||||
|
|
|
| ||
| The navigational data has been |
|
|
| |
MISSING NAV DATA | interrupted for more than 15 | Check the navigator. | |||
| seconds. |
|
|
| |
NAV DATA ERROR | The navigation data was |
|
|
| |
incomplete. | Check the navigator settings | ||||
| |||||
DEGRADATION OF NAV DATA | The navigation data was wrong. | Check the navigator settings. | |||
QUALITY |
|
|
| ||
|
|
|
| ||
PARAMETER ERROR OF NAV | The parameter setting was | Check the rudder system. | |||
MODE | incomplete. | ||||
|
|
|