Clarity CLARITY-P400 manual Troubleshooting, Hold Button, Last Number Redial Button, Flash Button

Telephone Operations

FLASH

BOOST CLARITY POWER

FLASH

BOOST

Figure 12

H. Hold Button

To put the line on hold, simply press the HOLD button and return the handset to its cradle. Notice the red light HOLD indicator.When you pick up an extension phone on the same line, the P400 will disconnect. Putting the call on hold also mutes the handset.

I. Last Number Redial Button

The P400 phone remembers the last number dialed from the phone up to 32 digits. Lift the handset and simply press the REDIAL button to dial the last number dialed.

Figure 13

J. Flash Button

The flash feature is used to access special telephone functions and ser- vices available from your local phone company, such as: call waiting, 3-way calling and others. Press this button to activate the flash feature.

FLASH

BOOST CLARITY

POWER

Figure 14

Troubleshooting

If any problem should arise during use of your P400 phone, try the suggestions listed below. Should the difficulty persist, contact Clarity or your authorized dealer for assistance.

SYMPTOM	CAUSE AND CORRECTIVE ACTION
No dial tone	Check all phone cord connections.
No number dialed when	No number stored in that memory button.
memory button pressed	See “Programming The Photo Directory”, p. 12.
Call cannot be dialed, or	See “Installation” section to
is dialed slowly	reset the dial mode switch, p. 11.
No audible ring	Make sure the ringer is not set
14	to “Off” position.