3.Never use a volatile substance such a gasoline or abrasive cleaners.
4.Do not splash water onto the unit.
Storing the air conditioner
If the unit will not be used for a long time, be sure to drain the air conditioner, clean the air filter, pull out the power supply plug and wrap around power cord hooks, and remove the batteries from the remote control before storage. After draining, keep the air conditioner running on FAN mode for at least 8 hours to dry the unit completely to prevent mold.
Troubleshooting
Problem | Possible Reasons | |
| - Check and reset the power plug. Wait 3 minutes and try to run the unit again. | |
| - The batteries in the remote may need to be replaced. Replace the batteries and try to run the unit again. | |
Air Conditioner does not operate | - Make sure the plug is properly plugged into the outlet. | |
| - The set temperature may be too close to room temperature. Lower the set temperature. | |
| - The air outlet may be blocked. Check the air outlet and remove any items that may be found. | |
| - Check the room for open doors or windows and close them. | |
| - There may be another appliance in the room giving off heat. Check the room and turn off the appliance. | |
Air Conditioner runs but does not cool | - The air filter may be dirty. Check the filter and clean if necessary. | |
| - The air exhaust or intake may be blocked. | |
| - The set temperature may be too high. Check the set temperature and reduce it if necessary. | |
Air Conditioner does not run and LED shows E4 | - There may be excess water in the unit. Drain the unit. | |
|
| |
Water is leaking from the unit | - Make sure unit is on a flat surface | |
- Drain the unit. | ||
| ||
Machine automatically turns off | - Timer may have been set to shut off. Turn power back on. | |
|
| |
LED display shows E4 | - Water full. Drain the unit. | |
|
| |
LED display shows E2 | - Temperature sensor error | |
|
| |
LED display shows E3 | - Evaporator error | |
|
|
13
