HOW TO ASSEMBLE THE MACHINE
To assemble the machine, follow this procedure:
1.Remove the brush housing, vacuum bags, hose, wand, handle assembly, canister housing, and tools from the carton.
2.Remove the canister housing and the brush housing from the plastic bags.
3.Install the canister housing on the brush housing. To install the canister housing, follow this proce- dure:
a.Position canister housing over brush housing (see figure 2).
b.Align pivot airway (A) and canister support pivot (B) with openings (C and D) in bottom of canister housing (see figure 2).
c.Lower canister housing completely onto brush housing until pin clicks into place and latches (see figure 3).
4.Install the handle assembly to the canister hous- ing. To install the handle assembly, follow this procedure:
a.Insert handle tube in the upper canister housing (see figure 4).
b.Lower handle completely into canister housing until mark on handle tube is below flush (see figure 5, item A). This insures the handle is properly seated.
c.Push handle latch into lock position (see figure 5, item B).
CD
A B
Figure 2
Figure 3
A
B
Mark on handle tube.
Figure 5 | Figure 4 |
|
|
10 | Clarke® Operator's Manual - D14 & D18 |