EN
How To Prepare the Machine For Operation
How To Remove Rotary Brush or Pad Driver (if equipped)
Toremovethebrushorpaddriverfromthemachine,follow this procedure:
1.Turn the key switch clockwise ("L" models only). Press the green "ON" button.
2.Raise the brush head by pressing and holding the brush up switch until brush head is in it's full up and rotated position.
3.Press the red "OFF" button or turn the key switch counterclockwise on machines equipped with key.
4To remove brush, rotate brush in the same direction to scrub rotation with a quick snapping action until brush releases (See Figure 21).
5. Reinstall brush housing if removed.
How To Change Or Rotate Cylindrical Brushes (if equipped)
To install or rotate brushes on the machine, follow this procedure:
1.Turn the key switch clockwise ("L" models only). Press the green "ON" button.
2.Raise the brush head by pressing and holding the brush up switch until brush head is in it's full up and rotated position.
3.Press the red "OFF" button or turn the key switch counterclockwise on machines equipped with key.
4Go to front of the machine and remove thumb screw from brush door (See Figure 22).
5.Lower door approximately 1/2 inch and slide door and bearing assembly off shaft (See Figure 23).
6.Remove brush spacer and brush by sliding off of brush shaft (See Figure 24).
7.Rotate brush or replace.
8.Slide brush on shaft and rotate slowly until drive pins are lined up with brush slots. Push brush all the way in.
9.Install brush spacer on shaft.
10.Slide brush door bearing assembly on shaft.
11.Raise door and install thumb screw.
DANGER: Operating a machine that is not completely or fully assembled could result in injury or property damage. Do not operate this machine unless it is completely assembled. Inspect the machine carefully before operation.
Figure 21
Figure 22
Figure 23
Figure 24
Clarke® Operator's Manual | Page |