EN
How To Operate The Machine
To
NOTE: On the "L" model, the machine will not move when the traverse speed knob is rotated fully counterclockwise.
7.Adjust the flow of clean solution to the flow desired.
8.Move the machine across the floor in the forward direction.
9.Make a 180° turn.
NOTE: When you make more passes across the floor, let the brush clean approximately 2 inches (5 cm) of the area already cleaned by the brush.
NOTE: During most cleaning procedures, apply and remove the solution in one operation.
How To Clean A Very Dirty Floor
To clean a very dirty floor, follow this procedure:
1.Apply solution to the floor.
2.Do not lower the squeegee. This will keep the vacuum motor off.
3.Lower the brush or pad and scrub the floor.
4.Scrub the floor again with additional solution and lower the squeegee.
5.Pick up all the solution with the squeegee.
Maintenance
WARNING: | Maintenance and repairs must be done by |
| authorized personnel only. |
WARNING: | Always empty the solution tank and recov- |
| ery tank before doing any maintenance. |
WARNING: | Keep all fasteners tight. |
These Maintenance Procedures Must Be Done EveryDay
Keep the machine clean, it will need fewer repairs and have longer life.
Do These Procedures When You Begin Your Work Period
1.Disconnect AC power from battery charger (follow charger instructions).
2.Store AC power cord to charger in machine storage compartment (See Figure 29).
3.Make sure the screen filter is installed properly in the recovery lid and is clean (See figure 30).
4.Make sure the recovery tank lid is on correctly (See Figure 30).
Figure 29
Figure 30
Page | Clarke® Operator's Manual |