|
|
| EN | |
| HOW TO CORRECT PROBLEMS IN THE MACHINE | |||
|
|
|
|
|
| PROBLEM | CAUSE | ACTION | |
|
|
|
|
|
There is no solution flow. | The solution tank is empty. | Fill the solution tank. | ||
|
| There is an obstruction in the solution hose | Remove the obstruction from the hose or filter. | |
|
| or filter. |
|
|
|
| The solution valve or electric wiring is | Repair or replace the valve or the electric | |
|
| damaged. | wiring. | |
|
| The control module is defective. | Replace control module | |
|
|
|
|
|
The solution flow does not stop. | The solution valve is open. | Close or Clean the solution valve. | ||
|
| The solution valve or wiring is damaged. | Repair or replace the valve and the wiring. | |
|
| The solution valve is dirty | Clean the solution valve. | |
|
| There is a damaged seat and washer in the | Replace the seat and washer. | |
|
| solution valve. |
|
|
|
| The control module is defective. | Replace control module. | |
|
|
|
| |
The machine does not remove all the | The squeegee is up. | Lower the squeegee. | ||
water from the floor. | The squeegee tilt is not correct. | To adjust, see the section titled "How to Adjust | ||
|
| |||
|
|
| the Squeegee". | |
|
| The recovery tank is full. | Drain the recovery tank. | |
|
| The screen filter is dirty. | Clean the screen filter. | |
|
| There is an obstruction or damage in the | Remove the obstruction or repair the damage. | |
|
| squeegee or squeegee hose. |
|
|
|
| The vacuum motor is not running. | Check for tripped breaker. Have an authorized | |
|
|
| service person make repairs. | |
|
| The squeegee hose is disconnected, or | Check and connect hose. | |
|
| damaged |
|
|
|
| The squeegee blade is damaged, worn, or | Turn or replace the squeegee blade. | |
|
| incorrectly installed. | Correctly install the squeegee blade. | |
|
| The gaskets on the cover of the recovery | Replace the gaskets. | |
|
| tank are damaged. |
|
|
|
|
|
| |
The batteries do not give the normal | The battery terminals are dirty or damaged. | Clean the terminals and connectors. Replace | ||
running time. |
| the damaged cables. Charge the batteries. | ||
|
| The electrolyte level is too low. | Add distilled water to each cell and charge the | |
|
|
| batteries. | |
|
| The batteries are not fully charged. | Charge the batteries for a full 16 hour charge. | |
|
| The charger is damaged. | Have an authorized service person repair the | |
|
|
| charger. | |
|
| The battery is defective. | Check voltage of each cell while discharging. | |
|
| The batteries are disconnected. | Connect the batteries. | |
|
| Brush is in heavy scrub setting. | Adjust Pressure. | |
|
|
|
|
|
|
|
|
|
|
Page | Clarke® Operator's Manual |