Classe Audio CDP-100 Classé can Bus Control Ports, RS-232 Control Port, AC Mains Power switch

Danger!

16

The remote Trigger In will respond to the presence of 5–12VDC, with tip polarity as shown below:

Similarly, Trigger Out will create a 12VDC signal that can source up to 100mA of current.

6Classé CAN Bus Control Ports

These RJ-45connectors are reserved for future control and communication applications using Classé Audio’s implementation of the Controller Area Network (CAN) Bus specification.

7RS-232 Control Port

This DB-9connector has two purposes:

•downloading new operating software into your player

•external control of your preamplifier by systems such as i-Command™, AMX® and Crestron™

For more information, please contact your dealer and ask about home automation systems.

8AC Mains Power switch

The main power switch for the CDP-100 is located at the right side of the rear panel. The player should be in standby mode before being switched off. Switching the unit on puts it in standby mode.

Potentially dangerous voltages and current capabilities exist within your CD player, even when disconnected from AC mains. Do not attempt to open any portion of the player’s cabinet. There are no user-serviceable parts inside your CD player. All service of this product must be referred to a qualified authorized Classé dealer or distributor.

9AC Mains Input

An IEC standard power cord (supplied) is used with the CDP-100. Plug the cord into the IEC outlet provided, and the other end into a suitable wall outlet.