Any combination of models in any order | Classe Audio CT-M600

22

The diagrams below illustrate how to connect the CAN-Bus hardware.

Any combination of models in any order.

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

For any system with SSP-300 or SSP-600.

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

NOTE: Daisy chain may need to be terminated with CAN-Bus Terminator.

Image 22

Classe Audio CT-M600, CA-M600 owner manual Any combination of models in any order

Contents

CA-M600 / CT-M600 600W Monaural Amplifier Class Important Safety Instructions Contents Word about installation Welcome to the Classé family Unpacking and Placement Operating voltage Warm up/break-in period Please read this manual… Special Design Features Extensive listening tests Extraordinary longevity Robust protection Front Panel Standby button & LED indicatorFlashing blue on power-up = On dim redPage Rear Panel Balanced XLR Input Single-Ended RCA Input Speaker Outputs Classé CAN-Bus Control Ports IR Input and Output USB Control Port DC Trigger Input and OutputRS 232 Control Port AC Mains InputPage CT-M600 stand-alone installation instructions Installation32 X 9/16 philips pan head screws 32 X 3/4 screws Make your speaker connections Configure your amplifier turn-on delay/amp numberMake your preamp/processor connections Double-check all your connections Classé Delta or CT Series Products Install the front panel CT-M600 onlyCAN-Bus Category 5 Network Cables Any combination of models in any order Using CAN-Bus CAN-Bus shared features Following CAN-Bus features are shared by all models Following CAN-Bus features are model-specific PlayLink Amp info Event log Care and Maintenance No sound, and Standby LED is blinking red TroubleshootingNo sound, and Standby LED is not lit Amplifier keeps shutting off AC mains fuse is blown Standby LED is flashing quickly Specifications Dimensions CA-M600 CT-M600 Page North America 514