Champion Level 1
USER MANUAL
7.Turn the tonearm into the final position where the tonearm is almost parallel to the right hand edge of the chassis. After that you can fix the tonearm in this position by holding the tonearm nut with one hand and turning the tonearm against, while using the other hand or tight the large nut with a wrench. Mount the tonearm counterweight.
8.To change the height of the tonearm lift, turn
it up to the high position and loosen the little screw at the front. Now you can move the plate of the lift. The distance between record and cartridge diamond when it is lifted up should be about 5mm. Tighten the screw again.
9.Place the belt first round the platter, then round the smaller diameter of the pulley (33 1/3 rpm).
10.The tension of the belt can be changed by turning the motor about its axis. The tension is correct if the correct turntable speed is achieved within 10 seconds. If the tension is too high, the motor could start to vibrate a little bit. If the tension is too loose, the turntable will not achieve a constant and correct speed.
11.Assemble the cartridge according to the manufacturer’s instructions.
Plattenteller
Motor
Riemen
Page 7 | clearaudio electronic GmbH 2006 |
