Clifford 50.7X manual Valet Take-Over, Etein Without Steppingoon the BRAKEP

minutes and 1 minute of runtime remaining, it sends the 2-way remote control a paging signal.

Points to remember:

If the hood is open or if the brake pedal is pressed, the vehicle will not remote start. The remote start shuts down:

ssWhen the brake pedal is pressed. ss The hood is opened.

ss When the remote start command is sent again from a remote control.

ss 7HEN THE RUNTIME EXPIRES

To drive your vehicle after it has been remote started:

1.'ETEIN WITHOUT STEPPINGOON THE BRAKEP

2.Insert the ignition key and turn it to the ON position.

3.Now, step on the brake.

The remote control will play the remote start shutdown tone. You have now taken direct control from the remote start system.

Valet Take-Over

4HEH6ALET 4AKE/VER FEATURETALLOWS THEHVEHICLEITO REMAIN RUNNINGGAFTERT the key has been removed from the ignition. This feature is useful for

OCCASIONSSWHEN YOUOWISH TO EXIT ANDNLOCK THEHVEHICLEIFOROSHORTTPERIODSI of time, but would like to leave the motor running and the climate controls on.

4O ENABLE 6ALET TAKEOVER WHILEITHEHVEHICLEIIS RUNNING PRESSE 1 time and the parking lights will flash after a couple of seconds turn off the

IGNITION ANDNTHEHCARASHOULD STAY RUNNING /NCE YOUOEXIT THEHVEHICLE YOUO can lock the system and the car will remain running. If the vehicle shuts down, then the unit did not enter valet take-over mode.

© 2008 Directed Electronics. All rights reserved. 19