Additional remote start features

Manual Transmission

If the vehicle has a manual transmission the proper steps must be fol- lowed before leaving the parked vehicle or the remote start feature is disabled.

1.Make sure the engine is running and the doors on the vehicle are closed.

2.Put the transmission in neutral.

3.Press on the brake in the vehicle.

4.Apply the emergency brake.

5.Release the brake.

Note: Pressing the brake pedal again after this step will disable the remote start feature.

6.Within 15 seconds activate the remote start from the remote.

7.The parking lights flash 5-times confirming that the remote start is active. If the parking lights do not flash 5-times, then repeat steps 1 - 6.

8.Turn off the ignition (the car stays running when key is turned off).

9.%XIT THE VEHICLE

10.Arm the alarm (the vehicle should shut off when arming the sys- tem).

You can now remote start the vehicle. If a door is opened or the alarm

IS TRIGGEREDGBEFORE THEHNEXT REMOTE STARTTACTIVATION THEHSYSTEM WILL NOTO remote start.

Note: 4OOENABLE 6ALET TAKEOVERWITH AAMANUAL TRANSMISSION IOPEN THE door and enter into manual transmission mode, as described above. 4HEHPARKINGKLIGHTS mASH ONETIME WHEN ENTERING 6ALET TAKEOVER /NCE

YOUOEXIT THEHVEHICLEIYOUOCANALOCK THEHSYSTEM ANDNTHEHCARAWILL REMAINA

28

© 2008 Directed Electronics. All rights reserved.

Page 28
Image 28
Clifford 50.7X manual Additional remote start features, Manual Transmission, XIT the VEHICLE