Board Installation
Use the following steps to install the card in the openGearTM 8310 frame:
1. Refer to the Owner’s Manual of the openGearTM 8310 frame to ensure that the frame
|
| is properly installed according to instructions. | |
|
|
|
|
|
| Heat and power distribution requirements within a frame may dictate |
|
|
| specific slot placement of cards. Cards with many |
|
|
| components should be arranged to avoid areas of excess heat |
|
Warning |
| particularly in frames using convection cooling. |
|
|
|
| |
|
| 2. After selecting the desired frame installation slot, hold the card by the edges and | |
|
| carefully align the card edges with the slots in the frame. Then, fully insert the card | |
|
| into the frame until the rear connection plugs are properly seated on the midplane and | |
|
| rear modules. | |
| This completes the procedure for installing the card in the openGearTM 8310 frame. | ||
Cable Connections
This section provides instructions for connecting cables to the installed BNC rear modules on the 8310 series frame backplane. Connect the input and output cables according to the following diagram. The input is internally terminated with 75 Ohms. It is not necessary to terminate unused outputs.
HD/SD SDI Input A
HD/SD SDI
Output A
HD/SD SDI
Output A
HD/SD SDI
Output C
HD/SD SDI
Input C
1 2
3 4
5 6
78
910
HD/SD SDI Input B
HD/SD SDI
Output B
HD/SD SDI
Output B
HD/SD SDI
Output C
HD/SD SDI
Output C
Figure 3. BNC Designations for the Card Rear Module
9006 Owner’s Manual • (V 1.0) | Page 11 of 18 |
