Quick Evaluation
Before Installation
Introduction
Test LoadA test load that can 
be plugged into the AC receptacle on the inverter 
for short term testing at a low power level.
To check your inverter’s performance before installation:
On/OffSwitchto Off | 1. Turnthe inverteroff (see page 11 |
| for details).If the power sourceis |
| a DC power supply,switch it off |
| as well. |
Installation
Requirements
Installation
InstallationRequirements
•
The inverter must be installed in an area that meets all of the following requirements:
A. Dry |
| Do not place in an area where water can drip |
or splash on the inverter. |
B. Cool |
| Ambient air temperature should be between 30°F |
| and 105°F (0°C and 40°C). The cooler the better. |
C. Ventilate |
ConnectTerminals
ConnectPower Source
On/OffSwitchto On
Connect Test Load
3.Connectcable to power source (see page 8 for details).
4.Check to make sure all connectionsare secure.
5.Turnthe inverteron. If the power sourceis a DC power supply,switch it on first.
6.Plug in the test load.
The invertershould supply power to the load. If the inverteris not workingproperly,refer to the troubleshootingguide on page 14 or power and protectionindicators sectionon page 12.
Allow at least one inch (three cm) of clearance |
around the inverter for proper airflow. Make sure |
that ventilation openings on the ends of the unit |
are not obstructed. |
CAUTION To avoid fire, do not cover or obstruct ventilationopenings. Do not install inverter in a zero- clearance compartment. Overheating may result.
CAUTION The inverter must only be connected to batteries with a nominal output voltage of 12 volts. It will not work with a 6 volt battery, and will be damaged if it is connected to a 16 volt battery.
WARNING This unit contains components which can produce arcs or sparks. To prevent fire or explosion, do not install in compartments containing a battery or flammable materials, or in a location which requires ignition protected equipment.
USB Connection
|
| Nothing Comes Close to a Cobra® 5 |
4 | ||
