Mounting and
Connecting Cables
Installation
Mounting
•
To mount your inverter:
1.Place the inverter on a flat surface with the mounting bracket against the mounting surface.
MountingBrackets
2.Mount to secure surface using mounting hardware that is corrosion resistant (not included).
MountingHardware
The inverter can be mounted horizontally or vertically.
ConnectingCables
•
Power wire and wiring are very important to the performance of the inverter. Because the inverter has a low voltage, high current input, low resistance wiring is essential between the battery and inverter. This is so it can deliver the maximum amount of energy to the load. Only use the cables providedwith your power inverter.
On/OffSwitchto Off | To connect the cables between |
| the inverter and the battery: |
1. Turnthe On/Off Switch on the inverterto the off position.If the power sourceis a DC power supply,switch it off as well.
Connecting Cables
Installation
2.Connect cable to the Power Input Terminalson right side panel of the inverter. The red terminal is positive (+) and the black terminal is negative
ConnectTerminals
3.Connect cable to your vehicle’s cigarette lighter socket.
Connect Power Source
NOTE If the inverter is to be used at levels above 150 watts for extended periods of time, a direct connection to the battery is recommended. Do not use the cigarette cord for loads higher than 150 watts. Please contact your local dealer or customer assistance for the proper cord for direct to battery connections.
CAUTION Reverse polarity connections (positive to negative) will blow inverter fuses and may permanently damage the unit. Such damage
is not covered by the warranty.
CAUTION Remove any jewelry (watch, ring, etc.). Be careful not to short circuit the battery with any metallic object (wrench, etc.).
|
| Nothing Comes Close to a Cobra® 7 |
6 | ||
