Operation
Mode Functions
|
|
|
|
Introduction | Operation | Customer Assistance | Warranty |
During channel scan (while receiving an incoming transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on that channel. Your radio will remain on that channel
Your microTALK radio can automatically scan the Privacy Codes (either• CTCSS 01 through 38 or DCS 01 through 104) within one channel. Only one set of privacy codes (CTCSS or DCS) can be scanned at a time.
and return to Standby mode.
b. Press the Channel Up or Channel Down button to resume scanning channels.
If you press the Talk button while scanning, but more than
10 seconds after receiving a transmission, you will transmit on the channel on which you last received a transmission. This will return the radio to Standby mode.
If you do not press any button within 10 seconds after receiving a scanned transmission, your radio will automatically resume scanning channels.
During channel scan (while not receiving a transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on the channel or channel/privacy code that was displayed before you entered mode functions or the channel on which, during scanning, you
last received a transmission. This will then return the radio to
Standby mode.
b. Press the Mode button to proceed to set privacy code scan on
Select Channel
Mode Button
Scan
Privacy Codes
Channel Buttons
To scan privacy codes:
1.While in Standby mode, press the Channel Up or Channel Down button to choose the channel on which you wish to scan privacy codes.
2.Press the Mode button until either the CTCSS or the DCS icon appears on the display and the Scan icon and the privacy code numbers flash on the display.
3.Press the Channel Up or Channel Down button to begin scanning privacy codes
within the channel you selected.
The Scan icon will continue to be displayed
when privacy code scan is on. Your radio will continue to scan privacy codes and stop as an incoming transmission is detected. Your radio will remain on that channel/privacy code for
10 seconds.
the channel that was either displayed before you entered mode functions or on which, during channel scanning, you last received a transmission (see page 19 for further details).
c. Press the Lock/Enter button to return to Standby mode on the channel/privacy code that was displayed before you entered mode functions or the channel on which, during scanning, you last received a transmission.
While setting privacy code scan, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code that was displayed before you entered mode functions.
18 | Nothing Comes Close to a Cobra® 19 |
