Set DCS Privacy Codes, Standby mode | Cobra Electronics CXR825C

Operation

Set DCS Privacy Codes

•

Mode Button	To select a DCS privacy code:
	1. After selecting a channel, press the Mode

	Introduction		Customer Assistance		Warranty
	Introduction	Operation	Customer Assistance		Warranty

•

You can use your microTALK radio to listen to NOAA All Hazards Radio channels transmitting in your area.

		button until the DCS icon appears and the
		small numbers flash on the display
	DCS Privacy Code	(01 through 104).
	DCS Privacy Code	NOTE
		NOTE
		If CTCSS is turned on at the channel
		selected, the display will flash the
		DCS icon and “OFF.” To switch from
	Channel Button	CTCSS to DCS, press the Channel Up
		or Channel Down button while the
		display is flashing “OFF.” The display
		will then show the small numbers
		flashing and you will then be able
		to proceed to step 2.

2. Press using the Channel Up or Channel Down

button to select a DCS privacy code. You can

hold the Channel Up or Channel Down button

Mode Button

Hazards Radio Icon

Channel Button

1.Press the Mode button until the WX (All Hazards Radio) icon, the currently selected All Hazards Radio channel, and signal strength are displayed.

2.Use the Channel Up or Channel Down button to change All Hazards Radio channels.

3.WX (All Hazards Radio) icon will continue to be displayed when All Hazards Radio is on. Choose one of the following:

a.Press the Mode button to proceed to other functions.

b.Press the Lock/Enter button to exit All Hazards Radio channels mode and return to Standby mode.

for fast advance.

3. When your desired DCS privacy code is

a. Press the Mode button to enter the new

setting and proceed to other functions.

b. Press the Lock/Enter button to enter the

new setting and return to Standby mode.

c. Do not press any buttons for 15 seconds

to enter the new setting and return to

*National Oceanographic and Atmospheric Administration

		Nothing Comes Close to a Cobra® 11
10 English