Using Your Radio
Operation
Speaker/Microphone/Charge Jack
•
Speaker/Microphone | To attach a speaker/microphone: |
/Charge Jack | 1. Open the speaker/microphone/charge |
| tab on top of your microTALK® radio. |
2. Insert the speaker/microphone accessory plug into the speaker/microphone/charge jack.
To connect a wall charger/adapter:
1.Open the speaker/microphone/charge tab on top of your microTALK® radio.
2.Insert the wall charger/adapter plug
into the speaker/microphone/charge jack.
Quick Start
|
|
|
|
Introduction | Operation | Customer Assistance | Warranty |
Battery Low |
| • |
| When battery power is low, the Battery Low icon | |
Battery Low |
| |
| will blink. Your batteries should be replaced or |
|
| recharged, if using rechargeable batteries. |
|
Auto Battery Save | • | |
|
| |
Battery Save Mode If there are no transmissions within 10 seconds, the | ||
| radio will automatically switch to Battery Save |
|
| mode and the Power Saver icon will flash in the |
|
| display. This will not affect the radio’s ability to |
|
| receive incoming transmissions. |
|
Communicating with Another Person | • | |
| 1. Press and hold the Talk button. | |
Talk Button |
| |
1. Press and hold the Mode/Power button to turn on your radio.
2.Press the Channel Up or Channel Down button to select a channel.
Both radios must be tuned to the same channel/privacy code to communicate.
3. Press and hold the Talk button while |
speaking into the microphone. |
Two Inches (5 cm) from Mouth
2.With the microphone about two inches (5 cm) from your mouth, speak in a normal voice.
3.Release the Talk button when you are finished talking and listen for a response.
You cannot receive incoming calls while pressing the Talk button.
Both radios must be tuned to the same channel to communicate.
4. When finished talking, release the Talk |
button and listen for a response. |
Turning on Your microTALK® Radio
•
Mode/Power | Press and hold the Mode/Power button until you |
| hear a series of audible tones indicating the radio is |
| on. |
Your microTALK® radio is now in Standby mode, ready to receive transmissions. The radio is always in Standby mode except when the Talk, Call or Mode/Power buttons are pressed.
To Select a Channel | • | |
| With the radio on, select any of the | |
Channel Button |
| |
| 22 channels by pressing the Channel Up |
|
| or Channel Down button. |
|
Both radios must be tuned to the same channel to communicate.
Channel Number 
Channels 1 through 7 are shared with FRS/ GMRS. Channels 8 through 14 are FRS only. Channels 15 through 22 are GMRS only.
See page 14 for FRS/GMRS frequency allocations and compatibility charts.
|
| Nothing Comes Close to a Cobra® 3 |
2 | ||
