Cobra Electronics LI 6000WXC owner manual Using Your Radio

Your microTALK® radio has a unique circuit designed to extend battery life. If there are

no transmissions for 10 seconds, the radio will automatically switch to Battery Save mode and the Power Saver icon will flash in the display.

This will not affect the radio’s ability to receive incoming transmissions.

Auto Battery Save

•

•

Your microTALK® radio is now in Standby mode, ready to receive transmissions. The radio is always in Standby mode, except when the Talk, Call, Mode or Power buttons are pressed.

Turning on Your microTALK® Radio • To turn on your radio:

Introduction

Insert Radio(s)

Using Your Radio

For charging microTALK® radio(s) in desktop charger:

1.Insert radio(s) into desktop charger as shown.

2. Insert round connector of 120 volt adapter into jack on back of charger.

3.Plug 120 volt adapter into electrical outlet.

Introduction Operation Customer Assistance Warranty

On/Off Power

–Press and hold the Power button until you hear a series of audible tones indicating the radio is on.

If charging light is not on, check position of radio. Radio should be upright. The charge indicator light will stay on as long as the radio is in the charging well and the battery pack is charging. After the battery pack is fully charged, the charge indicator light will turn off.

Battery Low Battery Low

•

It normally takes about 15 hours to fully recharge battery pack. Battery pack will not be damaged if they stay in the charging well longer than that.

Each port can charge one radio. Uses 120 Volt adapter.

Cobra recommends your radio is turned off while being charged.

The Basics to Get You Started

Your microTALK® radio is easy to use.

To get started, simply:

1.Press and hold the Power button to turn on your radio.

2.Press the Channel Up or Channel Down button to select a channel.

Both radios must be tuned to the same channel/privacy code to communicate.

3.Press and hold the Talk button while speaking into the microphone.

4.When finished talking, release the Talk button and listen for a response.

2 English

When battery power is low, the Battery Low icon will blink. Your batteries should be recharged.

Battery Save Mode

Talk Button		Communicating with Another Person
		To talk to another person:
	1.		Press and hold the Talk button.
		2.	With the microphone about two inches
Two Inches	(five		(five cm) from your mouth, speak in a
cm) from Mouth			normal voice.
	3.		Release the Talk button when you are
			finished talking and listen for a response.

You cannot receive incoming calls while pressing the Talk button.

Both radios must be tuned to the same channel/privacy code to communicate.

Nothing Comes Close to a Cobra® 3