6Pull the device by the latch release to remove the device from the module bay.

NOTICE: Insert devices into the module bay before you dock and turn on the computer.

7Insert the new device into the bay, push the device until you feel a click, and push the device latch release in so that it is flush with the computer.

8Replace the device screw.

9Turn on the computer.

Removing and Installing Devices While the Computer Is Running

CAUTION: Before performing these procedures, read the safety instructions on page 11.

NOTE: If the device screw is not installed, you can remove and install devices while the computer is running and connected to a docking device (docked).

Your computer ships with an optical drive installed in the module bay. However, the device screw is not installed in the optical drive but packaged separately. When you install your device in the module bay, you can install the device screw.

NOTE: You do not need to install the device screw unless you want to secure the module inside the computer for security purposes.

Using Batteries and Module Bay Devices

55

Page 55
Image 55
Dell 500m manual Using Batteries and Module Bay Devices