Cobra Electronics MR HH125 Memory Location Scan Mode, To Recall a Stored Memory Location

Operating Your Radio

MEM Icon

24 English

Advanced Operation

To Recall a Stored Memory Location:

1.Press the Memory/Escape button. The MEM icon will be turned On.

2.Press the Channel Up or Channel Down button to select the memory location. If a memory location has been programmed, its associated channel will display on the LCD. Your radio is now in Marine Standby mode on the selected memory location.

To Exit Memory Location Mode:

Press the Memory/Escape button to return the radio to Marine Standby mode. The last channel used in Marine Standby mode will now be displayed on the LCD and the MEM icon will disappear.

To Erase Stored Memory Locations:

1.Press and hold the Memory/Escape button for two (2) seconds. The memory location number will start flashing and the MEM icon will be turned On.

2.Use the Channel Up and Channel Down buttons to advance to the memory location you want to erase.

3.Press the Memory/Escape button to select the memory location. The memory channel number will stop flashing and the channel number will start flashing.

4.Use the Channel Up and Channel Down buttons to change the channel to read “00” at the selected memory location.

5.Press the Memory/Escape button to erase that memory location.

Repeat steps 2 through 5 to erase as many additional memory locations as you want.

6.Press and hold the Memory/Escape button for two (2) seconds. This will return the radio to Memory mode.

7.Press and release the Memory/Escape button again to return to Marine Standby mode.

Operating Your Radio

Memory Location Scan

MEM/ESC Button

Scan Button

Advanced Operation

Memory Location Scan Mode

During Memory Location Scan mode, the radio will rapidly scan through all programmed memory channels. Whenever any activity is detected on a channel, the radio will stop the scan for 10 seconds to allow you to listen briefly on that channel. It will then continue to scan unless you switch out of Memory Location Scan mode.

NOTE

If there are fewer than two (2) memory locations programmed in the radio, the Memory Location Scan option will not be available. At least two (2) memory locations need to be programmed to use the Scan button.

To Enter Memory Location Scan:

1.From Marine Standby mode, press the Memory/Escape button.

2.Press the DUAL WATCH/SCAN button. The radio will immediately begin to scan all pre-assigned memory channels. The SCAN and MEM icons will show on the LCD.

3.A signal on any channel will stop the scan for

10 seconds to allow you to listen to the traffic on that location.

4.Press the Channel Up or Channel Down button to resume scanning the Memory Location Scan channels or to change the scan direction.

5.To EXIT Memory Location Scan mode, press the DUAL WATCH/SCAN button again. The SCAN and MEM icons will disappear from the LCD and the radio will return to Marine Standby mode.

Nothing Comes Close to a Cobra® 25