Setup Mode Programming
Operating Your Radio
Setup Mode Programming
•
The following series of procedures is designed to allow you to set the programmable features of your radio. Correctly following these steps results in a minimal amount of radio setup programming time.
NOTE
When in the Setup mode, if you stop programming for longer than 15 seconds, your entry will be saved and the radio will go back to the Marine Standby mode. Pressing any of the
When you return to Setup mode and continue programming you will see the last “value” displayed. While in the Setup mode, you will not receive any signal reception.
Marine (VHF) Mode Programming
Programming these features will allow you to customize certain features of this radio to enhance your
Enter/Setup Button | Start from Marine Standby mode to begin Marine (VHF) |
| Setup programming. Press and hold the Enter/Setup button |
| for three (3) seconds to enter the programming mode. |
14 English
Setup Mode Programming
Operating Your Radio
U.S.A./International/Canada Channel Maps
Three (3) sets of VHF Channel Maps have been established for marine use in the U.S.A., Canada, and the rest of the world (International). Most of the channels are the same for all three (3) maps, but there are definite differences (see table in the Appendix). Your radio has all three (3) maps built into it and will operate correctly in whichever area you choose.
Set Channel Map | To Set Channel Map Operating Area: |
1.The Channel Map mode is the first mode that begins the
Marine (VHF) Setup programming.
2. U, I and C will display, with the current setting (the U icon is the default) flashing.
3. Press Channel Up/Down buttons to select the U, I or C icon.
4.Press Enter/Setup button to save this entry and move to
Active Channel Map Icon
the next setup programming mode – Roger Beep.
NOTE
One or two of the channel maps might have been disabled for sales of this radio in some countries.
Channel Up/Down Buttons
Nothing Comes Close to a Cobra® 15
