OPERATION | English |
Product Information
This microTALK® radio has been manufactured to meet all required standards for radio equipment using PMR 446 frequencies as authorized. The use of this
Caring for Your Radio
Your microTALK® radio will give you years of
•Handle the radio gently.
•Keep it away from dust.
•Never put the radio in water or in a damp place.
•Avoid exposure to extreme temperatures.
Desktop Charger and
Rechargeable Batteries
Each port can charge one radio. Uses 230 volt adaptor. Use only Cobra NiMH batteries, model
Cobra recommends your radio is turned Off while being charged.
Radio Power
To Turn Your Radio On: | Power Button |
–Press and hold the POWER button until you hear a series of audible tones indicating that the radio is On.
Your microTALK® radio is now in LISTENING MODE, ready to receive transmissions. The radio is always in LISTENING MODE, except when the TALK, CALL or MODE buttons are pressed.
To Turn Your Radio Off:
– Press and hold the POWER button.
Battery Low Indicator
To Insert Batteries in Radio:
1.Remove belt clip by releasing belt clip latch and sliding clip up.
2.Pull down on lock tab to remove battery cover (on back of radio).
3.Insert
Remove Belt Clip
Lock Tab
Insert Batteries
When battery power is low, |
| Battery Low |
| |
|
| |||
the BATTERY LOW indicator |
|
|
|
|
will blink, indicating that |
|
|
|
|
|
|
|
| |
batteries should be recharged |
|
|
|
|
or replaced. |
|
|
|
|
|
|
|
|
WARNING: Only the supplied NiMH batteries can be recharged.
Battery/Power Saver
If there are no transmissions
NOTE: Estimated operation time on full charge: 12 hours.
These rechargeable batteries
must be recycled or disposed of properly in compliance with all applicable laws. They must not be thrown in the rubbish bin. Some countries and local authorities require recycling and have established collection programs. Please contact your local waste disposal authority for instructions.
WARNING: Do not put batteries into fire or expose to high heat. They may explode.
For Charging Cobra’s microTALK® Radio(s):
1. Insert radio(s) into the | Insert Radio(s) | |
charger as shown. |
|
|
|
|
2. Insert round connector of
230 volt adaptor into jack on back of charger.
3.Plug 230 volt adaptor into mains socket.
If charging light is not On, check position of radio. Radio should be upright.
The charge indicator light will stay On as long as the radio is in the charging well, even after the batteries are fully charged.
It normally takes about 15 hours to fully recharge batteries. Batteries will not be damaged if they stay in the charging well longer than that.
within ten (10) seconds, the unit will automatically switch to Battery Save Mode and POWER SAVER will appear in
the display. This will not affect the unit’s ability to receive incoming transmissions.
Communicating with
Another Person
To Talk To Another Person: |
|
1. Press and hold the TALK |
|
Talk Button | |
button. |
|
2.With the microphone about 5 cm (2 inches) from your mouth, speak in a normal
voice. | 5 cm (2 Inches) | |
From Mouth | ||
|
3.Release the button when you have finished talking and listen for a response.
You cannot receive incoming
calls while pressing the TALK button.
NOTE: Both radios must be tuned to the same channel and privacy code to communicate.