Mode Functions
Operation
Memory Location Scan
•
Your microTALK® radio can automatically scan up to 10 programmed Memory Locations.
If there are one or fewer memory locations programmed in your radio, the scan memory locations option will not be available. To program at least two memory locations, see program memory locations on page 12.
|
|
|
|
Introduction | Operation | Customer Assistance | Warranty |
If you press the Talk button while scanning, but more than
10 seconds after receiving a transmission, you will transmit on the memory location on which, during scanning, you last received a transmission. This will return the radio to Standby mode.
If you do not press any button within 10 seconds, your radio will automatically resume scanning memory locations.
During memory location scan (while not receiving a transmission), you can choose from the following:
Mode/Lock Button
Scanning Locations
Channel Buttons
To scan memory locations:
1.Press the Mode/Lock button until the Scan icon, Memory icon and the memory location number flash on the display.
2.Press the Channel Up or Channel Down button to begin scanning memory locations.
The Scan icon and the Memory icon will continue to be displayed when memory location scan is on. Your radio will continue to scan memory locations and stop if an incoming transmission is detected. Your radio will remain on that memory location for 10 seconds.
While setting memory location scan, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions.
a. Press and hold the Talk button to communicate on the channel/privacy code that was displayed before you entered mode functions or memory location on which, during scanning, you last received a transmission.
b. Press the Mode/Lock button to proceed to other functions.
c. Press the Enter/Hi•Low button to return to Standby mode on the channel/privacy code that was displayed before you entered mode functions or the memory location on which, during scanning, you last received a transmission.
To reduce the number of memory locations being scanned, you may
10 Call Tone Settings
•
You can choose from 10 different call tone settings to transmit a unique call alert.
Mode/Lock Button To change a call tone setting:
1. Press the Mode button until the letter “C” and |
the current call tone number (01 through 10) |
During memory location scan (while receiving an Incoming
is displayed. |
transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on that memory location. Your radio will remain on that memory location and after 10 seconds of no activity, radio will start memory location scan again.
b. Press the Channel Up or Channel Down button to resume scanning memory locations.
Call Tone Setting
Channel Buttons
2.Press the Channel Up or Channel Down button to hear the other call tone settings.
3.Choose one of the following:
a.Press the Mode/Lock button to enter the new setting and proceed to other functions.
b.Press the Enter/Hi•Low button to enter the new setting and return to Standby mode.
|
|
|
|
18 English | Nothing Comes Close to a Cobra® 19 | ||
