Using the Mode Button

A D VA N C E D O P E R AT I O N

ENGLISH

ENGLISHA D VA N C E D O P E R AT I O N

MODE

Button

The MODE button allows you to use and program the various functions of your microTALK® radio. If you press and hold the MODE button, the LCD will cycle through the different functions.

MODE

Recalling Memory Locations

To recall a channel you have stored in a memory location:

1. Press the MODE button until the Memory icon and a

memory location flashes.

MODE

Button

Programming Memory Locations

Your microTALK® radio has ten (10) memory locations (0-9) for storing your most frequently used channels and privacy codes.

To program locations:

1.	Push the MODE button until the Memory icon and the
	memory location flashes.
2.	Press the CHANNEL SELECT button up or down to select
	the memory location you wish to change.

Button

CHANNEL

SELECT

Button

2. Select your desired memory location by pushing the

CHANNEL SELECT button up or down.

Your radio will stay at this memory location until you exit Memory Function mode by pressing the LOCK button.

Repeat steps 1 and 2 to recall other memory locations.

Using the Scan Function

Your microTALK® radio can automatically scan main channels (1-22), the privacy codes (00-38) within one main channel, or memory locations.

CHANNEL

SELECT

Button

TALK

Button

LOCK

MODE Button

Button

3.	Press and release the MODE button again. The Memory
	icon and the main channel number will flash.
4.	Press the CHANNEL SECTECT button to select the main
	channel you wish to store.
5.	Press the MODE button again to store the main channel
	in memory and move to privacy code selection. The
	privacy code number begins flashing and the Memory
	icon continues to flash.
6.	Press the CHANNEL SELECT button to select the privacy
	code (00-38) you wish to store.
7.	Press the LOCK button to program your selection.
	You may also press the TALK button to transmit your
	selected channel and privacy code, which will be stored
	into the memory location you are using.
8. a) Press and release the LOCK button to return to
	Standby mode at your new memory location.
	b) Press and release the MODE button to save the
	memory location and proceed to other functions.

(NOTE: To “unprogram” a memory location you programmed previously, select 00 for both the main channel and privacy code in steps 4 through 6.)

MODE

Button

CHANNEL

SELECT

Button

To scan main channels:

1.Press the MODE button until the Scan icon and main channel number flashes.

2.Push the CHANNEL SELECT button up or down and the radio will begin scanning the main channels.

(NOTE: The radio “ignores” privacy codes while scanning main channels.)

3.The radio will continue to scan all main channels and stop if an incoming transmission is detected. The radio will remain on that channel for ten (10) seconds. During that time you can:

a)Press and hold the TALK button and talk. The radio will remain on that channel and return to Standby mode.

b)Push the CHANNEL SELECT button up or down to resume scanning main channels.

c)Press the MODE button to proceed to privacy code scanning (see following page).

If you do not press any button within ten (10) seconds, the radio will automatically resume scanning main channels.

Cobra Electronics PR 945 operating instructions Using the Mode Button, Recalling Memory Locations

Models: PR 945