A D VA N C E D O P E R AT I O N | ENGLISH |
ENGLISHA D VA N C E D O P E R AT I O N
CHANNEL
SELECT
Button
MODE |
Button |
CHANNEL
SELECT
Button
Using the Scan Function (continued)
To scan privacy codes:
1. | While in Standby mode, press the CHANNEL SELECT |
| button up or down to choose the main channel you |
| wish to scan. |
2. | Press the MODE button until the Scan icon and the |
| privacy code number flashes. |
3. | Push the CHANNEL SELECT button up or down and the |
| radio will begin scanning privacy codes within the main |
| channel you selected. |
4. | The radio will continue to scan privacy codes and stop if |
| an incoming transmission is detected. The radio will |
| remain on that code for ten (10) seconds. During that |
| time you can: |
| a) Press and hold the TALK button and talk. The radio |
| will remain on that channel and privacy code, then |
| return to Standby mode. |
| b) Push the CHANNEL SELECT button up or down to |
| resume scanning privacy codes. |
b)Push the CHANNEL SELECT button up or down to resume scanning memory locations.
c)Press the MODE button to proceed to other functions.
If you do not press any button within ten (10) seconds, the radio will automatically resume scanning memory locations.
You must have at least two (2) memory locations programmed in order to scan memory locations.
(NOTE: If you want to reduce the number of memory locations being scanned you need to ”unprogram“ all unwanted locations by changing both the main channel and privacy code to 00. See Programming Memory Locations, page 7.)
“Roger Beep” Confirmation Tone
Your listener will hear an audible tone when you release the TALK button. This alerts the other party that you are finished talking and it is OK for them to speak. This feature can be turned On or Off.
c) Press the MODE button to proceed to memory |
location scanning (see below). |
If you do not press any button within ten (10) seconds, the radio will automatically resume scanning privacy codes.
MODE |
Button |
To turn “Roger Beep” On or Off:
When turning On your microTALK® radio for the first time, “Roger Beep” will be On.
1. Press the MODE button until the “Roger Beep’’ icon |
flashes on the LCD. The current On or Off setting is |
MODE |
Button |
CHANNEL
SELECT
Button
To scan memory locations:
1.Press the MODE button until the Scan icon, Memory Location icon and memory location number flashes.
2.Push the CHANNEL SELECT button up or down and the radio will begin scanning memory locations.
3.The radio will continue to scan all memory locations and stop if an incoming transmission is detected. The radio will remain on that location for ten (10) seconds. During that time you can:
a)Press and hold the TALK button and talk. The radio will remain on that memory location channel and return to Standby mode.
CHANNEL
SELECT
Button
displayed. |
2. Press the CHANNEL SELECT button up or down to select |
“Roger Beep” On or Off. |
3. a) Press the MODE button to enter the new setting and |
proceed to other functions. |
b) Press the LOCK button to enter the new setting and |
return to Standby mode. |
c) Do not press any buttons for 15 seconds to enter the |
new setting and return to Standby mode. |
The setting you select will be saved when you turn your radio Off and On again. When the “Roger Beep” is On, the “Roger Beep” icon will be displayed.
9
10
