![](/images/new-backgrounds/1217730/21773011x1.webp)
O P E R AT I O N | ENGLISH |
ENGLISH | O P E R AT I O N |
Recalling Memory Locations | To scan main channels: |
Using the Scan Function (continued)
c) Press the MODE button to proceed to |
To recall a channel you have stored in a memory location:
1.Press the MODE button until the Memory icon and a memory location flashes.
MODE button
2.Select your desired
memory location | CHANNEL | |
by pushing the | SELECT | |
button | ||
CHANNEL SELECT | ||
| ||
button up or |
| |
down. Your radio |
| |
will stay at this | ENTER | |
memory location | button | |
until you exit |
| |
Memory Function |
| |
mode by pressing |
| |
the ENTER button. |
|
3.Repeat steps 1 and 2 to recall other memory locations.
Using the Scan Function
Your microTALK® radio can automatically scan main channels
1.Press the MODE button until the Scan icon and main channel number flashes.
2.Push the CHANNEL SELECT button up or down and the unit will begin scanning the main channels. (NOTE: The unit “ignores” privacy codes while scanning main channels.)
3.The radio will continue to scan all main channels and stop if an incoming transmission is detected. The unit will remain on that channel for 10 seconds. During that time you can:
a)Press and hold
the TALK button | TALK button | |
and talk. The radio | ||
| ||
will remain on that |
| |
channel and return |
| |
to Standby mode. |
|
b)Push the CHANNEL SELECT button up or down to resume scanning main channels.
c)Press the MODE button to proceed to privacy code scanning (see following page).
If you do not press any button within 10 seconds, the radio will automatically resume scanning main channels.
To scan privacy codes:
1.While in Standby mode, press the CHANNEL SELECT button up or down to choose the main channel you wish to scan.
2. Press the MODE | MODE |
button until the | button |
Scan icon and the |
|
privacy code |
|
number flashes. |
|
3.Push the CHANNEL SELECT button up or down and the unit will begin scanning privacy codes within the main channel you selected.
4.The radio will continue to scan privacy codes and stop if an incoming transmission is detected. The unit will remain on that code for 10 seconds. During that time you can:
a)Press and hold the TALK button and talk. The radio will remain on that channel and privacy code, then return to Standby mode.
b)Push the CHANNEL SELECT button up or down to resume scanning privacy codes.
memory location scanning (see below). |
If you do not press any button within 10 seconds, the radio will automatically resume scanning privacy codes.
To scan memory locations:
1.Press the MODE button until the Scan icon, Memory Location icon and memory location number flashes.
2.Push the CHANNEL SELECT button up or down and the unit will begin scanning memory locations.
3.The radio will continue to scan all memory locations and stop if an incoming transmission is detected. The unit will remain on that location for 10 seconds. During that time you can:
a)Press and hold the TALK button and talk. The radio will remain on that memory
location channel and return to Standby mode.
9 | 10 |