Cobra Electronics XRS 9430 Setting the IntelliMute Activation Point, Tone Voice, Set Engine Revs

9493 XRS 9430-D-B2 4/10/06 11:54 AM Page 10

Settings

Your Detector

What to Remember While Using IntelliMute

IntelliMute works with both City and Auto Mute modes.

Whenever your engine revs are below the activation point,

the dot next to the large character on the right side of the display will remain lit. Above the activation point, the dot will blink twice every two seconds.

Below Activation Point	Above Activation Point
X K Ka V S c	X K Ka V S c

If, for any reason, the unit stops sensing your engine’s revs,

IntelliMute will indicate an error and automatically turn off.

The rev point you set will be stored in the unit’s memory when power is turned off and recalled each time the power is turned on.

NOTE

The rev point must be reset if you use your detector in a different vehicle.

NOTE

When initially choosing your IntelliMute activation point, a setting of approximately 300 to 600 RPMs above idle is recommended. You can reset the activation point at any time to fit your individual preferences and driving style.

Setting the IntelliMute Activation Point

Your detector must be installed in your vehicle.

CAUTION

Do not attempt to set the rev point while driving.

Your vehicle should be parked and idling.

IntelliMute must be turned on before setting the activation point. Depending on whether the unit is in Tone Alert or Voice Alert mode, you will hear a series of beeps or voice messages as you follow the steps on page 11.

10 English

Settings

Your Detector

IntelliMute Button
Press and release
To Set the IntelliMute Activation Point
Press and hold	Tone		Voice		Visual Display
the IntelliMute
	Two beeps		Set Engine Revs		None
button for two
seconds.
Rev your engine to	None		None		Three bars will
the level you wish					flash in succession
to set (recommend					1		2	3
slightly above idle)
and hold revs steady
for two seconds.
At the desired	Three beeps		IntelliMute Set		All three bars flash
rev level, press					three times
and release the					1		2	3
IntelliMute
button.
		NOTE
		If the unit is unable to sense usable pulses within three
		seconds or if you do not set a rev point within 20 seconds
		of beginning these steps, IntelliMute will indicate an error
		and automatically turn off.
		Tone		Voice		Visual Display
		Four beeps		IntelliMute Error,		E appears
				followed by
				IntelliMute Off			X K Ka V S E

Nothing Comes Close to a Cobra® 11