UK/IRL
5.3 Remote control (if applicable)
The remote control is only meant to regulate the flames, it functions only when the pilot burner is ignited. It is therefore not possible to ignited the appliance with the remote control or to
The
Features:
-Manual control will always remain possible.
-The remote control is a radio frequency type and has been approved internationally.
-The remote control generates a unique safety code every time you activate the transmitter, its similar to those used in a car.
-The remote control is easy to install retrospectively.
5.3.1Installation remote control
1.Connect the mains adapter to the receiver box. The adapter is set to the correct voltage in the factory 4.5V.
fig. 21
2. Slide the receiver box into the holder.
UK/IRL
fig. 22
3.Connect the wires to the gas valve (see fig. 22).
4.Check that there are batteries in the transmitter. See "Replacing batteries", see chapter 10.4.4.
5.Set the on/off switch on the receiver to "on".
Setting the right transmission code
The receiver has to learn the code from the transmitter, which is already done at the factory. However the code disappears if the receiver is disconnected from the mains for a longer period.
1.Push the "mod" button on the receiver and hold it for 3 seconds.
2.The green control lamp will light up and stay on. Repeat this step if it doesn't.
3.Push a button on the remote control. The control lamp on the receiver should now go out.
4.Again push a button on the remote control. The lamp starts flashing and will switch off eventually.
5.The receiver now recognizes the remote control. The remote control now functions.
6.Check if you can hear a sound and the motor runs when you push a button on the remote control.
30 |
|
|
| 31 |
|
|
