UK/IRL
10.4.3 Setting the right transmission code
he receiver has to learn the code from the transmitter, which is already done at the factory. However the code disappears if the receiver is disconnected from the mains for a longer period,
1.Set the on/off switch on the receiver to "on".
2.Push the "mod" button on the receiver and hold it for 3 seconds.
3.The green control lamp will light up and stay on. Repeat this step if it doesn't.
4.Push a button on the remote control. The control lamp on the receiver should now go out.
5.Again push a button on the remote control. The lamp starts flashing and will switch off eventually.
6.The receiver now recognizes the remote control. The remote control now functions.
7.Check if you can hear a sound and the motor runs when you push a button on the remote control.
UK/IRL
10.4.4 Changing the batteries
There is no risk of electric shock as the low voltage supply is similar to that used in torches. Always turn off the appliance before changing batteries.
Remote control
1. Remove the cover on the back of the remote control.
2. Carefully remove the battery clip along the side. Pay attention not to pull the wires.
3. If necessary, remove the old batteries and place the new ones: 2 x LR03 Alkaline long life 1.5 V.
| + | 4. | Click the battery clip into the remote control and close the cover. |
| |||
|
|
| |
| AAA | 5. | It might be possible that you have to set the transmission code |
AAA |
| ||
|
| after changing the batteries (see 10.4.3). | |
|
|
|
+
Note
Batteries are chemical waste and should be disposed in accordance with local regulations.
fig. 29
changing batteries
52 |
|
|
| 53 |
|
|
