Assembly cont.
Step 4 (cont)
■The support ring and each log is marked with a Letter which corre- sponds to the location where logs should be placed. Each log also has recesses that are lettered which indicate where adjoining logs are to be placed.
Start with log “A” then “B”, etc.
Step 5 (cont)
■ Attach regulator to tank. |
| ■ Install tank. |
|
|
|
|
|
|
Leak Check
WARNING
•Perform leak test outdoors.
•Extinguish all open flames.
•NEVER leak test when smoking.
•Do not use the fireplace until connection has been leak tested and does not leak.
Step 5
• You must provide propane gas and propane tank. Use a standard 20 lb. |
propane tank only. The L.P. cylinder must have a |
in a Type 1 L.P. gas cylinder valve outlet. |
• Use this fireplace only with a propane vapor withdrawal supply system. |
See Chapter 5 of the Standard for Storage and Handling of Liquefied |
Petroleum Gas, ANSI/NFPA 58. Your local library or fire department will |
have this book. |
• A minimum supply pressure of 11.0 W.C. is required for the purpose of |
input adjustment for propane gas. |
• The pressure regulator and hose assembly supplied with the fireplace |
must be used. |
• The installation must conform with local codes, or in the absence of local |
codes, with National Fuel Gas |
Code, ANSI Z223.1. |
• A dented, rusted or damaged |
propane tank may be hazardous |
and should be checked by your |
tank supplier. Never use a propane |
tank with a damaged valve connec- |
Cylinder Valve
Regulator/Cylinder
Connection
•Make
•Apply several drops of solution where regulator connects to Cylinder.
•Make sure control knob is OFF.
• Turn Cylinder Valve ON.
If bubbles appear at connection, there is a leak.
•Turn Cylinder Valve OFF.
•If leak is at Regulator/Cylinder Valve connection: disconnect, reconnect, and perform another leak check. If you continue to see bubbles after several attempts, cylinder valve is defective and should be returned to cylinder’s place of purchase.
If NO bubbles appear at connec- tion, the connection is secure.
• Turn Cylinder Valve OFF.
NOTE: Whenever gas connection is loosened or removed, you must perform a leak test.
tion. |
• The propane tank must be |
constructed and marked in |
accordance with the specifications |
for LP gas cylinders of the U.S. |
Department of Transportation |
(DOT). |
• Never connect an unregulated |
propane tank to the heater.
Control Knob
5
