Coleman 5178 Series manual To Light, English-3, Remove lantern parts from package

■Remove lantern parts from package.

Igniter Electrode		Ventilator-Bail
	Lantern Frame	Assembly
Globe		Base
Ball		Mantles
Nut

WARNING

•Replace any mantle with a hole in it. A hole can cause lantern to overheat and create a hazard. Never operate lantern without heat shield.

■Note: Use Coleman 16.4 oz. disposable propane cylinders. The LP-gas cylinder(s) used with lanterns must be constructed and marked in accordance with the specifications for LP-gas cylinders of the U.S. Department of Transportation or Transport Canada, CAN/CSA B339.

■Always use genuine Coleman® #21 size mantles. If using Insta-Clip® II tabbed mantles, follow the instructions on the mantle package.

■Place lantern frame in base.

■If using tie style mantles, tie mantles around grooves in burner. (Fig. 1)

■Distribute folds on mantle evenly. Cut off surplus string 1/4" (0.6cm) from knot. (Fig. 2)

■For INSTASTART™ electronic ignition lanterns, be careful that mantle does not snag

on electrode.

■Take lantern outdoors away from

ignition sources.

■Turn fuel valve off. (Fig. 8)

Fig. 8

■Remove protective cap from top of propane cylinder. Save cap for use in storing. (Fig. 9)

Fig. 1

Fig. 2

DANGER

• EXPLOSION - FIRE HAZARD

• Propane is heavier than air and can accumu-

late in low places. If you smell gas, leave the

■Light bottom of mantle evenly. Burn until nothing but white ash remains. Once the mantle has been burned, it is very fragile. Be careful not to touch it with finger or match. (Fig. 3, 4)

area immediately.

• Always attach or detach propane source out-

doors; never while lantern is lighted, near

flame, pilot lights, other ignition sources or

Fig. 3

Fig. 4

while lantern is hot to touch.

• Always light & use lantern outdoors.

• This lantern must not be exposed to flamma-

ble vapors or liquids during lighting.

• This lantern is red hot during use and can

ignite flammables too close to the mantles.

Keep flammables at least 12 inches from the

sides and 48 inches from the top of the

lantern. Keep gasoline and other flammable

■ Complete assembly. (Fig. 5, 6, 7)

liquids and vapors well away from lantern.

Fig. 5

Fig. 6

Fig. 7

■Screw propane cylin- der into lantern. Take care not to cross-thread. Hand tighten only.

(Fig. 10)

■Set lantern into base. (Fig. 11)

To Light

WARNING

If you smell gas:

1.Do not attempt to light appliance.

2.Extinguish any open flame.

3.Disconnect from fuel supply.

4.Call 1-800-835-3278.

English-3