ÖÖNOTE: Step 19 applies to you only if your grill is set up from the factory to use NATURALGAS. If your grill is set up from
the factory to use LP GAS, skip back to Step 18.
Step
19
TO CONNECT ATTHE FUEL SOURCE:PUSH BACK THE SLEEVE OF
THE QUICK DISCONNECT COUPLINGAND INSERT THE HOSE CON-
NECTOR. RELEASE THE SLEEVEAND PUSH THE CONNECTOR INTO
THE COUPLER UNTIL THE SLEEVE SNAPS FORWARD.
TO DISCONNECT ATTHE FUEL SOURCE:PUSH BACK THE SLEEVE
AND PULL OUT THE CONNECTOR. THIS AUTOMATICALLYSHUTS
OFF THE GAS. IMMEDIATELYPLACE THE RUBBER PLUG INTO THE
QUICK DISCONNECT END.TURN OFF THE FUEL SOURCE SHUT-OFF
VALVEIF APPLICABLE.
WARNING: DURING ASSEMBLYOF GRILL AND WHEN
CONNECTING OR DISCONNECTING THE HOSE FROM THE FUEL
SUPPLYLINE, INSURE THAT THE GAS SUPPLY HOSE IS FREE OF
KINKS AND/OR DAMAGE AND ISAT LEAST 3” AWAY FROM HOT
SURFACES SUCHAS THE GRILL CASTING.
CAUTION: MAKE SURE THE GAS CONTROLKNOBS
ARE IN THE “OFF” POSITION BEFORE CONNECTING THE LOWER
END OF THE HOSE TO THE FUEL SOURCE.
YOUR NATURALGAS COMPANY MUST INSTALL AND CONNECT THE
GAS SUPPLYLINE TO THE GRILL.
19-A
19-B 19-C
Quick Disconnect Coupling
Hose Connector
Rubber Cap
Quick Disconnect Coupling
Rubber Plug
ÖÖAttach a NATURALGAS
line to the grill.
27
PLACE THE RUBBER PLUG ONTO THE GAS SUPPLYLINE. THEN
ATTACHTHE SOCKET END OF THE QUICK DISCONNECT COUPLING
ONTO THE GAS SUPPLYLINE. TIGHTEN WITH A WRENCH.
LEAK TESTAT THE FUEL SOURCE CONNECTION WITH SOAP AND
WATER. THERUBBER PLUG IS USED TO PROTECT THE CONNEC-
TOR WHEN THE HOSE CONNECTOR IS NOT INSERTED.
POSITION THE RUBBER CAP ONTO THE HOSE CONNECTOR.
USE THE CAP TOCOVER THE HOSE CONNECTOR WHEN NOT
ATTACHEDTO THE FUEL SOURCE.