CAUTION
Acollision with the grill, as with any metal object, could cause
injury. Use care when moving a portable gas grill.

Moving the grill:

• Move grill slowly. DO NOTrun with or pull the grill behind you;
it could hit you from behind causing injury.
• DO NOT move the grill while it is lit or hot, or with objects on
the cooking surface(s) or side table(s).

After moving the grill:

• Check all gas connections for leaks that could occur from the
movement.
• Check the venturi tubes to be sure they are still over the ori-
fices.

Steps to follow before storing grill:

• Clean the grill.
• Coat the burner lightly with cooking oil to retard rusting.
• For outdoor use only. If grill is stored indoors, detach and
leave cylinder outdoors. If left outdoors, turn off the fuel supply
to the L.P. cylinder and cover the grill for protection from the
weather. Grill covers may be purchased from a grill dealer or
manufacturer.
WARNING
If the grill is not in use, the gas MUST be turned off at the fuel
supply cylinder.
Moving and StorageTroubleshooting
DANGER
NEVER attempt to operate your grill without orifices in the
valves. Aserious and immediate fire hazard would result.
• COOKING GRATES: Clean cooking grates with mild soap and
hot water. Remove stubborn residue with a mild cleanser or scrub
brush. Use a brass-bristle brush on porcelain-coated grates. DO
NOT use a commercial oven cleaner.
• PORCELAIN-COATED HEATTENTS™: Wipe off grease
residue using a cleaning pad and a brass-bristle brush to knock
off residue. Use care not to damage porcelain finish. Replace
heat tents to their correct position.
• GRILLINTERIOR: Remove grates and porcelain heat tents.
Scrape side with tools and remove excess grease and cooking
residue.
Cleaning and Maintenance
cont.

Orifices

Valves

REPRESENTATIVE ILLUSTRATION
24

Problem: Burner will not light or has incom-

plete burner flame.

Possible Causes and Solutions:
1. Make sure the 9-volt battery is fresh.
2. Check for spider webs or insect nest in venturi and clean venturi.
3. Lack of fuel. Check to see cylinder valve is open and cylinder
has fuel.
4. Misalignment of venturi on orifices. Position venturi over orifices.
5. Burner ports, orifices, valves or hose have blockage. Clean the
components.
6. If burner lights with match but not igniter, check ceramic elec-
trode position in gas collector and condition of igniter wire and
its connections. Perform igniter test and replace any damaged
parts.
7. Crimped fuel supply hose needs straightened.
8. Regulator failure or damaged hose need to be replaced by an
authorized service dealer.
9. Make sure hose to cylinder is properly assembled (pg. 26).

Problem: Yellow flame.

Possible Causes and Solutions:
1. Check for spider webs or insect nest in venturi and clean
venturi.
2. New burner may have residual oil which will burn off.
3. Clean off any food residue, grease or seasoning salts on
burner.
4. Air may be in cylinder if cylinder was not properly purged.
Use up remaining gas; the yellow flame may disappear
with use.
5. Venturi may be misaligned and needs to be lined up over orifice.
33