SUNDOME™ 7’x 7’
Instructions apply to Part Number 9260N707
When You Are Ready To Set Up Your Tent
–Select a level campsite clear of rocks, branches and other hard or sharp objects.
–Do not set up your tent under trees. ™ –For best results in windy conditions, position the end of tent into the wind.
–See owners manual for more tips.
| POLE ASSEMBLY PARTS |
Main Tent | Part No. 9260A702 |
Poles | | |
| |
Rainfly Pole | | |
| |
Part No. 9260-703 |
| | |
| | |
Rainfly Part No. 9260M704
1 Layout & Positioning
of Tent, Pole
Assembly
–Layout and position tent with door facing desired direction. (illus. 1)
–Unzip door
–Stake down tent corners only, using the rings at the end of the stake loops. Keep the floor taut.
–Assemble Frame Poles by interlocking shock-corded poles. This will make two long poles.
–Insert the poles diagonally into Pole Sleeves.The center of the poles should cross forming an “X” in the middle of tent. (illus. 1)
–Fasten Frame Tie on top of tent over both poles. (illus. 1), (illus. 3)
| Assembled | |
| poles | Frame Tie |
| inserted |
| |
| through | |
| pole | |
| sleeves | |
| | illus. 1 |
| | illus. 2 Tent stake |
| | through ring |
2 Connect Frame to Tent
–Insert one end of main tent pole end onto pin of ring and pin system, at tent corner. (illus. 4)
–Go to opposite end of pole and gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole
–Repeat for second pole
illus. 3
Frame Tie
illus. 5
Tent frame set-up
illus.4
Insert pole end onto pin & ring