Liquid Propane Gas Conversion Instructions
You are now ready to install
the new LP manifold.
16.NOTE: New screws for the bezels are inserted into the new LP manifold at the factory. Remove them before proceeding with Step 17.
17.Place the new manifold into the grill body with the control knob stems going outward through control panel front (Fig. 15).
18.Reattach the bezels to the manifold with the screws. Make sure that "off" is facing up on the bezel (Fig. 12 & 13).
19.Reattach the control knobs onto the manifold stems, making sure the arrow is facing upwards (Fig. 11).
20.Reattach the flexline on the left of the grill to the back infrared valve using an adjustable wrench (Fig. 10).
21.Reattach the flexline on the right of the grill to the new manifold using the adjustable wrench (Fig. 9).
22.Reinstall burners into the grill body. Line up the burners with the valves on the manifold, making sure they are level. Make sure the burners are fully over the valves (Fig. 16).
23.Reattach the igniters and their heat shields (removed in Steps 2, 3, and 4) to the burners (Fig. 2, 3, and 4).
24.Reattach the rear heat shields before attaching the front heat shield to be sure the burners remain over the valves (Fig. 2).
25.Reinstall the front heat shield (Fig. 5, 6, and 7).
26.Reinstall the heat tents (Fig. 1).
27.Reinstall the cooking grates.
Control Knob
Stems
Fig 15
Valves
Burners
Fig 16
6
