Grill Assembly — 8200 Series
Side Burner Installation (continued)
10.From underneath the side shelf, push the threaded portion of the electrode module through the round hole (Fig. 22).
11.Assemble the plastic hex nut and igniter button back onto the electrode module. These items should be hand tightened only (Fig. 23).
12.Assemble the side burner control knob (Fig. 24).
13.The igniter wire for the side burner is shipped loose. Attach the large spade to the igniter terminal underneath the side burner (Fig. 25).
14.Attach the small spade to one of the four open terminals on the electrode module (Fig. 26a). Notice that the wire may be neatly wrapped around the fuel line.
15.Three wires are factory installed to the main burner electrodes. Locate the loose ends of these three wires (they exit the right side panel through a grommet) and attach them in any order to the tabs in the back of the electrode module (Fig. 26b).
NOTE: It does not matter which ignition wire goes to which tab on the electrode module.
Fig. 22
Fig. 23
Fig. 24
Fig. 25
Fig. 26a
Fig. 26b
13
