Harbor Freight Tools 90374 Unpacking, Assembly and Operating Instructions, See Figure D

18.WARNING! Some dust created by power sanding, sawing, grinding, drilling, and other construction activities, contain chemicals known (to the State of California) to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement or other masonry products, arsenic and chromium from chemically treated lumber. Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. (California Health & Safety Code 25249.5, et seq.)

19. WARNING! People with pacemakers should consult their physician(s) before using this product. Operation of electrical equipment in close proximity to a heart pacemaker could cause interference or failure of the pacemaker.

20. WARNING! The warnings, precautions, and instructions discussed in this manual cannot cover all possible conditions and situations that may occur. The operator must understand that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

UNPACKING

When unpacking, check to make sure all the parts shown on the Parts Lists on pages 18, 19, 20, and 21 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.

ASSEMBLY AND OPERATING INSTRUCTIONS

NOTE: For additional information regarding the parts mentioned in the following pages, refer to the Assembly Diagrams on pages 18, 19, 20, and 22.

1.NOTE: The Battery (1A) requires charging. The first charge requires 5 hours charge time prior to using a cordless tool. (See Figure D, next page.)

2.The Battery (1A) should only be re-charged when the Flashlight Bulb (7C) begins to dim or a cordless tool begins to run slowly. (See Figure D.)

3.When the Battery (1A) requires re-charging, a 3 to 5 hour charge allows the tool to operate at full power. Do not re-charge the Battery longer than 5 hours, as damage to the Battery and/or Flashlight or cordless tool will occur.

(See Figure D.)

SKU 90374 PAGE 10