To Set Up cont.
■Close cartridge
compartment.
NOTE:
If compartment will not close, check to be sure lever is in “OFF” position. If the problem persists, take the stove back to your dealer.
Failure to follow these procedures to properly install the cartridge and close the door can result in a gas leak.
To Light
WARNING
If you smell gas:
1.Do not attempt to light appliance.
2.Extinguish any open flame.
3.Disconnect from fuel supply.
4.Call
To Light cont.
This stove is equipped with a piezo electric igniter.
■Pull the Lever
down to the “ON” position.
■Turn Control Knob counterclockwise until you hear a click indicating that a
spark has been produced.
■If the stove does not
light, turn the Control Knob back to (
) position and repeat previous step.
■After three (3) failed attempts, turn the gas supply off by turning the Control Knob clockwise to (
) position and return
Lever to the up position.
■Open door, remove cartridge and shake to verify that it is not empty.
CAUTION: When cartridge needs to be replaced: if stove in use, do not touch the hot stove or any items that are on the stove until they have cooled.
■If empty, replace cartridge following the “To Set Up” section on page 4.
■Adjust flame with
Control Knob.
■Flame should be blue with hint of yellow on tips.
WARNING
•BURN HAZARD
•Never leave stove unattended when hot or in use.
•Keep out of reach of children.
To Turn Off
■Turn Control Knob clockwise to (
) position
and return Lever to the up position.
5
