Combi 8000 Series instruction manual Securing Base With Lap and Shoulder Belt, Fig. aLeg

33

Securing Base With Lap and Shoulder Belt:

WARNING DEATH or SERIOUS INJURY can occur

To prevent ejection, metal support ring MUST be used when using lap and shoulder belt.

Follow steps 1 through 6 on page 17 of this manual.

7After buckling vehicle belt, install metal support ring (fig. a) around lap and shoulder belt:

-Install metal support ring on the opposite side of base from the vehicle buckle (fig. b and fig. c).

Metal Support
Ring
Open	Inner
Slot
	(fig. a)Leg

-Pinch lap belt and shoulder belt together.

-Slide belts into open slot in metal support ring and hook under inner leg to position lap belt and shoulder belt inside metal support ring (fig. d).

NOTE: Both the lap belt and shoulder belt MUST be inside metal support ring (fig. d).

8Tighten vehicle belt to secure the base. Follow steps 7 through 10 on page 18 of this manual.

Keep metal support ring for future use. Store in LATCH compartment when not in use.

Metal	Vehicle	Metal
Support Ring		Support Ring
	Buckle

Passenger	Driver
Side	Side
(fig. b)	(fig. c)

(fig. d) TICS25

CMBI ®

Designed by Parents, for Parents

Keep this instruction manual for future use.

Store instruction manual inside LATCH storage compartment located on front of lower base.

© 2003 COMBI International Corporation TICS1103

COMBI International Corporation • 189-199 Easy St. • Carol Stream, IL 60188 •

Customer Service Telephone 1-800-992-6624 • Se Habla Español 1-630-871-0404 •

Fax 1-630-871-0606 • www.combi-intl.com •

10:00 a.m. - 5:00 p.m. Central Time • Monday - Friday