![](/images/new-backgrounds/1231914/23191421x1.webp)
19
Securing Infant Car Seat Without Base:
WARNING
DEATH or SERIOUS INJURY can occur
•Not all vehicle seat belts can be used with a car seat. Read vehicle owner’s manual and “Vehicle Seat Belts” section in this manual.
1Refer to vehicle owner’s manual to identify the seating location which can be used with a car seat. Check for specific instructions for car seat use.
2After selecting a seating location, adjust vehicle seat back into most upright position.
3Place car seat
4Carry handle can be moved to the vehicle use position (see “Carry Handle Operation” section).
5Thread vehicle lap belt through vehicle lap belt guides on car seat (fig. a) and buckle vehicle belt. Be sure vehicle lap belt is not twisted. Do not place shoulder belt through vehicle lap belt guides.
6Press down firmly on car seat to compress vehicle seat cushion while tightening vehicle lap belt (fig. b).
7Adjust recline using the recline indicator on the side of car seat (fig. a). Line on recline indicator must be in green striped zone.
If line is not in green striped zone, place a tightly rolled up towel, blanket or firm foam (pool noodle) under end of car seat contacting vehicle seat back.
If base can not be adjusted to locate the line in the green striped zone:
1.Try a different seating position.
2.Do not use this infant car seat.
Vehicle Lap
Belt Guides
Towel or
Pool Noodle
(fig. a)
Level
Indicator
NOTE: Vehicle must be parked on horizontal surface during this installation.
8Check for secure installation. Pull front to back and left to right to check for secure installation (fig. c). Vehicle lap belt MUST stay tight.
If vehicle lap belt does not stay tight, see “Installation with Lap/Shoulder Belts” below.
9Recheck car seat recline. Verify line is in green striped zone of recline indicator.
Installation with Lap/Shoulder Belts:
•When using vehicle lap/shoulder belts, shoulder belt may be used for additional support. Place shoulder belt around back of Tyro™ (fig. d) and through the vehicle shoulder belt guide on back of car seat shell (fig. e). If shoulder belt is too short to go around back of Tyro™, position shoulder belt through the lap belt guide above the vehicle buckle and against vehicle seat back (fig. f). Do not route shoulder belt through lap belt guides on
both sides of car seat.
• Lap/shoulder belt with free sliding latch plate:
-Pull out on latch plate (fig. g). If belt slides freely through latch plate, a belt
-Some combination lap/shoulder belts with free sliding latch plates
may be converted into an “automatic locking mode” that will allow use without a belt
Removal Of Infant Car Seat From Vehicle:
1 Unhook shoulder belt from behind car seat and unbuckle vehicle seat belt.
2Remove lap belt from vehicle lap belt guides.
3 Push in handle buttons on each side of handle and rotate to upright carry use position (see “Carry Handle Operation” section).
4Remove car seat from vehicle.
(fig. b)
(fig. c)
(fig. d)
Latch
Plate
20 | (fig. f) | (fig. g) |