Zenoah manual Set Up,  12 , PUTTING ON WAIST PAD BC4401DW only, Installing Cutting Head

Models: BC4401DW

1 36
Download 36 pages 50.73 Kb
Page 12
Image 12
■PUTTING ON WAIST PAD (BC4401DW only)

Set Up

PUTTING ON WAIST PAD (BC4401DW only)

• Warp the waist pad around the shaft tube and the throttle wire.

INSTALLING CUTTING HEAD

1.While locking the gear shaft by inserting the attached bar into the upper holder and the gear box, loosen and remove the hexagon bolt(left-handed)

2. Fit the spacer attached to the head assembly between the upper and lower holders. Then screw in the cutting head to the gear shaft over the holders. Hand- tighten it securely.

12

Page 12
Image 12
Zenoah manual Set Up,  12 , PUTTING ON WAIST PAD BC4401DW only, Installing Cutting Head